Vanguard CT-7000 S3 Bedienungsanleitung PDF herunterladen (Seite 47)

REV 1 CT-7000 S3 USER’S MANUAL

3.2.11. Configuring the Resister Type Transducer Settings

The CT-7000 S3 provides three resistor type transducer channels. The transducer must be

configured before it can be used with the CT-7000 S3. Up to 9 resistor transducer setups can be

stored in the CT-7000 S3’s Flash EEPROM. When a resistive transducer is used with the CT-7000

S3, it is shown as transducer #1 on the timing report as shown in Figure 17. 7000 S3’s Flash

EEPROM.

Creating a New Resistor Type Transducer Setup

Follow the steps below to create a new resistor type transducer setup:

a. Start from the “START-UP” menu:

Press the [4] key (SETUP).

b. The following screen will be displayed:

Press the [2] key (MEASUREMENT UNITS).

c. The following screen will be displayed:

Press the

[4] key (RES ENCODER).

SELECT UNITS:

1. ENGLISH

2. METRIC

3. ROTARY ENCODER

4. RES ENCODER

1. ANALYSIS POINTS

2. MEASUREMENT UNITS

3. SHOT DESCRIPTION

4. NUMBER OF CHANNELS

5. NEXT PAGE

1. TIME BREAKER 09/12/13

2. GET RESULTS 10:10:10

3. SAVE/RESTORE

4. SETUP

5. DIAGNOSTICS

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 136 137

Keine Kommentare

Vanguard CT-7000 S3 Bedienungsanleitung Seite 47